Case 28 - mBot Neo Rotates X°

Part 1   Objective

After you upload the program, toggle the joystick left and right to set the angle that mBot Neo rotates, and then press button A to start mBot Neo.


Part 2   Preparation

  • Assembled mBot Neo x 1

  • USB cable (Type-C) x 1

  • Computer with network access x 1

Assemble mBot Neo, connect CyberPi to the computer by using the cable, open mBlock 5 (PC client or web version), connect CyberPi, and select the Upload mode.



Part 3   Programming

Add mBot2 shield from the Extension center, and then program with the blocks added.


Part 4   Practice

You can measure the angle with an angle ruler to see whether the angle that mBot Neo rotates is the same as that you set.



Was this article helpful?
1 out of 1 found this helpful



Article is closed for comments.