1. Makeblock Help Center
  2. Products
  3. mBot Ranger

    Case 1 - Control the LEDs

    Avatar
    Makeblock Technical Support Team

    Part 1  Objective

    After you upload the program, the LEDs on Auriga blink, light up one by one, or are displayed in other ways as programmed.

    mr1.gif
    mr2.gif

    Part 2  Preparation

    • Auriga x 1

    • USB cable x 1

    • Computer with network access x 1

    Connect Auriga to the computer by using the USB cable, open mBlock 5 (PC client or web version), connect CyberPi, and select the Upload mode.

    mr3.gif

    mr4.gif

    Part 3  Programming

    1. RGB LEDs blink: when you turn on mBot Ranger, the LEDs are on and off alternately.mr5.gif

      1. RGB LEDs light up one by one: when you turn on mBot Ranger, the RGB LEDs light up one by one. After all the LEDS are on, they go off.

        mr6.gif

    Part 4  Practice

        1. Try to change the light color of the LEDs.
        2. Try to make the LEDs light up and then go off one by one.
    Was this article helpful?
    8 out of 11 found this helpful

    Comments

    0 comments

    Please sign in to leave a comment.