Why is the mBot Ranger keep running even after updating the firmware?

It is properly because mBot Ranger received a special instruction from Makeblock App, and keep following it if the "Line Following" or "Avoid Obstacle" wasn't properly closed, which cannot be reflashed by firmware updating.

 

In this situation, you may need to reconnect the mBot Ranger with Makeblock App, enter "drive" mode and then close it, sample as below:

mceclip0.png

Was this article helpful?
0 out of 0 found this helpful

Comments

1 comment
  • If I cannot find the "running mode" is there another way to get it to stop? 

    -1

Please sign in to leave a comment.