How to reset default program manually with mBlock 3.4.x

This article applies to: mBot, mBot Ranger, Starter, Ultimate, Ultimate 2.0

Devices required: PC (here we use windows); Makeblock robot kit (here we use mBot as an example; USB cable

 

Step 1

Connect your Makeblock robot to mBlock 3.4.x.

Step 2

Go to Connect->Reset Default Program->mBot, wait until it says Upload Finish.

Ps: reset button on the main board cannot get same effect as “reset default program”. The reset button only flashes the program which is uploaded last time.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.